300MW锅炉低NOx燃烧系统改造效果分析

针对日益严重的环境污染、锅炉热效率低等问题，阐述了燃煤锅炉炉内空间分级燃烧技术、煤粉浓淡高效分离技术改造项目和特点，提出了对燃烧器系统、一次风管道、二次风系统和空预器系统等系统进行具体的低氮改造措施。分析了300 MW燃煤锅炉低氮改造后的热经济性和安全性。经试验验证，1号锅炉低氮改造后，锅炉NOx 排放量大幅减少，排放浓度降到了280 mg／m3。     

循环载荷下煤裂隙演化试验研究

为了研究循环载荷下的煤体裂隙演化特征，在不同应力水平和不同频率条件下分别进行煤样破坏力学及声发射试验。结果表明:应力-应变曲线呈疏-密-疏的变化特征，对应的振铃数柱状图呈U型；上限应力点的应变值、累积能量、撞击计数均随循环次数增加而上升，曲线呈倒S型；煤裂隙演化经历了原始裂隙闭合、新生裂隙稳定发育和裂纹贯穿破坏等3个不同阶段；循环载荷的应力水平和加载频率对煤体疲劳寿命的影响具有差异性，对煤体裂隙演化和破坏模式均有明显影响。     

大肠杆菌吸附-化学还原法用废含金催化剂制备金纳米线

采用大肠杆菌吸附-化学还原法,以大肠杆菌(ECCs)为模板、十六烷基三甲基溴化铵为保护剂、抗坏血酸为还原剂,由废含金催化剂制备金纳米线(AuNWs)。采用XRD,SEM,TEM等技术对AuNWs进行表征。研究了AuNWs对罗丹明6G(R6G)和4-巯基苯甲酸(4-MBA)的拉曼散射信号的增强效果。实验结果表明:在制备过程中加入微生物ECCs,可使金回收率提高约20百分点;当溶液pH小于4时,反应2 h后,有大量呈线状的AuNWs聚集沉降,金回收率可达99%1以上。表征结果显示,AuNWs呈多晶结构,晶格间距为0.23 nm。表面增强拉曼散射分析表明,AuNWs对R6G和4-MBA具有良好的拉曼光谱增强性能。     

Ti3C2纳米层状材料对废水中Cr（Ⅵ）的光催化去除性能

以Ti₃AlC₂为原料,采用HF刻蚀工艺制备出12种Ti₃C₂纳米层状材料,对其形貌进行了表征,并考察了以其作为光催化剂对废水中Cr（Ⅵ）的处理效果。实验结果表明：HF体积分数为80%、刻蚀时间为48 h时得到的MX-80-48的形貌较好;MX-80-48具有类似石墨烯的二维层状结构,纳米层厚度约20~50 nm,孔径2~10 nm,比表面积14.8 m²/g,在400~700 nm可见光范围内表现出强烈的吸光性;当Cr（Ⅵ）的初始质量浓度为40.00 mg/L、MX-80-48投加量为200 mg/L、pH=2、反应时间4 h（暗反应1 h+光照3 h）时,Cr（Ⅵ）去除率可达100%。     

The accounting method and application of CO2 emissions responsibility by the electricity sector at the provincial level in China

When accounting the CO₂ emissions responsibility of the electricity sector at the provincial level in China,it is of great significance to consider the scope of both producers’ and the consumers’ responsibility,since this will promote fairness in defining emission responsibility and enhance cooperation in emission reduction among provinces.This paper proposes a new method for calculating carbon emissions from the power sector at the provincial level based on the shared responsibility principle and taking into account interregional power exchange.This method can not only be used to account the emission responsibility shared by both the electricity production side and the consumption side,but it is also applicable for calculating the corresponding emission responsibility undertaken by those provinces with net electricity outflow and inflow.This method has been used to account for the carbon emissions responsibilities of the power sector at the provincial level in China since 2011.The empirical results indicate that compared with the production-based accounting method,the carbon emissions of major power-generation provinces in China calculated by the shared responsibility accounting method are reduced by at least 10%,but those of other power-consumption provinces are increased by 20% or more.Secondly,based on the principle of shared responsibility accounting,Inner Mongolia has the highest carbon emissions from the power sector while Hainan has the lowest.Thirdly,four provinces,including Inner Mongolia,Shanxi,Hubei and Anhui,have the highest carbon emissions from net electricity outflow- 14 million t in 2011,accounting for 74.42% of total carbon emissions from net electricity outflow in China.Six provinces,including Hebei,Beijing,Guangdong,Liaoning,Shandong,and Jiangsu,have the highest carbon emissions from net electricity inflow- 11 million t in 2011,accounting for 71.44% of total carbon emissions from net electricity inflow in China.Lastly,this paper has estimated the emission factors of electricity consumption at the provincial level,which can avoid repeated calculations when accounting the emission responsibility of power consumption terminals（e.g.construction,automobile manufacturing and other industries）.In addition,these emission factors can also be used to account the emission responsibilities of provincial power grids.     

期权理论在排污权初始分配中的应用

排污权交易是当前总量控制目标下最具潜力的环境政策,它兼有环境质量保障和成本效率优化的特点.在对国内外排污权交易和初始分配充分考察的基础上,提出了在排污权初次分配中引入期权机制的尝试,并对这种方法的理论基础作了分析和讨论.     

Composition of Floating Debris in Harbours of the United States

As part of a programme to characterize floating anthropogenic debris in the aquatic environment, the US Environmental Protection Agency (EPA) conducted 18 field surveys in the harbours of major metropolitan cities of the east, west, and Gulf coasts of the United States and the Mid-Atlantic Bight. the surveys were designed to provide information on the types, relative amounts, and distributions of aquatic debris in different geographic regions of the United States. Neuston nets (0.33 mm mesh) were used to collect surface debris during outgoing tides on two or three consecutive days in selected areas of each city. After each net tow, the debris, which ranged in size from small resin pellets to large plastic sheeting pieces, was identified, categorized, and counted. the data are being used to qualitatively characterize aquatic debris in coastal metropolitan areas, to examine potential regional variations, and to tentatively identify potential sources.     

Evaluation of Carbon Uptake and Emissions by Forests in Korea During the Last Thirty Years (1973–2002)

The contribution of Korean forests to carbon sequestration for anthropogenic carbon emissions was evaluated. In addition, monitoring of carbon species released from forest fires was conducted. Despite a high carbon uptake by Korean forests, a tremendous increase in fossil fuel burning resulted in a small contribution by forests to carbon removal. The removal efficiency had a 5–31% range with an average of 12% during the period 1973–2002. In 2000, the amount of carbon released from burned trees corresponded to 1.6% of carbon uptake by forests. The distribution of surface CO concentration (ppb) derived from MOPITT (Measurement of Pollution in the Troposphere) showed high CO levels over the East/Japan Sea on April 10, 2000 when the largest forest fires occurred along the east coast of Korea. Trajectory analysis and ground CO measurements also indicated that CO levels over the East/Japan Sea were influenced by forest fires. This study suggests that continuous monitoring of carbon emissions from forest fires is needed for a more reliable estimate of carbon flux in the environment.     

Types of Ectomycorrhiza as Pollution Stress Indicators: Case Studies in Slovenia

Mycorrhiza is the main spatial and temporal linkage between different constituents in a forest ecosystem. The functional compatibility and stress tolerance of ectomycorrhizal types is species specific, and therefore the information on the ectomycorrhizal community structure can add to the understanding of processes in forest ecosystems and can also be applied as tools for bioindication of pollution stress in forest soils. We have studied the effects of pollution (N and S) on trees and forest soils by: (1) quantification of ECM types diversity as in situ indicators in forest stands, (2) determination and quantification of pollution-sensitive or -insensitive ECM types as passive monitors, (3) root growth and development of ECM on nonmycorrhizal spruce seedlings, planted at the studied sites (active monitors), and (4) ECM infection (a bioassay based on mycorrhizal inoculum potential) of seedlings in an experimental set-up as ex situ testers. ECM species richness for Norway spruce trees (Picea abies) showed higher values in unpolluted sites than in polluted ones, while the differences were not significant for European beech trees (Fagus sylvatica). As pollution-sensitive or -insensitive ECM species in spruce forests, we suggest Hydnum rufescens (sensitive) and Paxillus involutus (unsensitive). Mycorrhizal potential in Norway spruce seedlings as a bioassay for soil N and S pollution was effective, and is suggested as an additional, standardized and widely comparable system in bioindication of soil pollution.     

Magnetic mapping of fly-ash pollution and heavy metals from soil samples around a point source in a dry tropical environment

The Singrauli region in the southeastern part of Uttar Pradesh, India is one of the most polluted industrial sites of Asia. It encompasses 11 open cast coalmines and six thermal power stations that generate about 7,500 MW (about 10% of India’s installed generation capacity) electricity. Thermal power plants represent the main source of pollution in this region, emitting six million tonnes of fly-ash per annum. Fly-ash is deposited on soils over a large area surrounding thermal power plants. Fly-ashes have high surface concentrations of several toxic elements (heavy metals) and high atmospheric mobility. Fly ash is produced through high-temperature combustion of fossil fuel rich in ferromagnetic minerals. These contaminants can be identified using rock-magnetic methods. Magnetic susceptibility is directly linked to the concentration of ferromagnetic minerals, primarily high values of magnetite. In this study, magnetic susceptibility of top soil samples collected from surrounding areas of a bituminous-coal-fired power plant were measured to identify areas of high emission levels and to chart the spatial distribution of airborne solid particles. Sites close to the power plant have shown higher values of susceptibility that decreases with increasing distance from the source. A significant correlation between magnetic susceptibility and heavy metal content in soils is found. A comparison of the spatial distribution of magnetic susceptibility with heavy-metal concentrations in soil samples suggests that magnetic measurements can be used as a rapid and inexpensive method for proxy mapping of air borne pollution due to industrial activity.